SEG2T "Elster" Radio Link Transceiver |
| |
| The SEG2T was a radio link transceiver manufactured by the LORENZ firm, and was used to link up radio stations in different parts of occupied Europe. It was also used as a wireless telephone link. The power output of the SEG2T is 80 milliwatts. |
| |
| Specifications: |
| |
| Principle: |
Radio link transceiver for radio and telephony purposes. Antenna is the Chireix-Mesny type. |
| Frequency range : |
475 to 525 MHz |
| Power Requirements: |
2 Volt DC filament - 2 Amps, 130 Volt DC Anode - 200 mA. |
| Speaker system: |
This set has no built-in loudspeaker. It requires a separate loudspeaker or headset. |
| Case material: |
Metal case |
| Vacuum Tubes: |
2X DS310, 1X RV2P800, 2X RL2T2 |
| |
|
The front view of the SEG2T. The cosmetic condition is excellent! . |
|
|
The LORENZ manufacturer's data on top of the case. |
|
|
Back of the case with the porcellain-isolated socket for the Chireix-Mesny antenna. |
|
|
The voltmeter and the amp-meter. These are specifically manufactured for the SEG2T. |
|
|
The On/Off switch and the communications mode selector. |
|
|
The power connector - confugured typically for a transceiver. |
|
|
The communications interface device connectors. |
|
|
Cover off.......Bottom view of the SEG2T |
|
|
View of the SEG2T from the top. |
|
|
Right side. |
|
|
Left side. |
| |
|
View from the rear |
| |
