Fu. H. E. v
 

The Fu.H.E.v receiver belongs to the series of "half-height" monitoring receivers similar to the Fu.H.E.u and the Fu.H.E.u1. A well constructed, battery-operated 8-tube, heterodyne receiver of cast "Electron" alloy. A rotating turret of intricate design carries the HF, oscillator and mixer tank circuits. 4 sets of 4 tank circuits, each shielded by a light-weight die-cast "can". Iron-core inductances are used in antenna and circuit coils. Variable ceramic capacitors provide parallel trimming. The contacts are not the brush type; instead, a long cam furnishes pressure to contact fingers. IF is 3000 KHz.

 
Specifications
 
FREQUENCY RANGE:

24 - 160 MHz

NUMBER OF CRYSTALS:
PRESET FREQUENCIES:
ANTENNA:
TUNING:(MO OR CRYSTAL)
Master Oscillator
SENSITIVITY:
100 uV input for 1 mV output
SELECTIVITY:
POWER SOURCE:
Batteries. For filament: 2,4 Volt storage cell; for plate: 90 Volt storage cell
SIMILAR SETS :
POWER OUTPUT:(WATTS)
TUBES (TYPE and NUMBER):

Circuit: 8x RV2.7P700 as RF, MIX, IF1, IF2, IF3,Audion detector, Audio, BFO.
Circuit: SD1A as local oscillator
USE:
For intercept purposes and for monitoring command nets.
TYPE OF SIGNAL:

CW, tone and voice
RANGE: (MILES)
TO COMMUNICATE WITH:
   
TO REPLACE IN PART:  
TRANSPORTATION:
Pack, plane or vehicle
 

 
The receiver with the front cover off.

 

 
Close up of the front panel.

 

 
Manufacturer data. Year of manufacture was 1942.

 

 
Waffen Amt stamp - this is the original paint.

 

 

 

 

BACK